CONTACT

Contact : Mr. Chen
Mobile : +86-18626363628
Tel : +86-510-88998399
Fax : +86-510-88998399
Add : 1st Floor, Building 5#, No. 380, Jincheng East Road, Xinwu District, Wuxi
Web : www.wxdiscovery.com
E-mail : robin@wxdiscovery.com

Problems

HOME > News > Problems >
Causes of errors in rack processing
For the parts of mechanical equipment, many need to have precision, but for many reasons, the surface roughness of the rack is different. The staff of the rack manufacturer below will explain the reason for the error in the rack processing.

1. The precision of the machine tool transmission chain is not high. During operation, vibration or impact occurs, which affects the instability of the machine tool transmission.

2. The contact between the spindle of the table and the conical guide surface of the table is not satisfactory. The contact of the conical rail is large, the table rotates heavily, and vibration occurs during operation, which causes errors in processing.

3. The knife mechanism is not working properly, and the knife is scraped onto the surface of the workpiece.

4, the pinion knife sharpening quality is poor.

5. The feed rate is too large, causing the cutting of the rack to be not timely, which results in rough surface of the rack.

6. The rack blank is not installed properly, and vibration occurs during cutting.

7. The cutting fluid is dirty or rushed into the cutting groove, causing the surface quality of the rack to be unqualified.

Related News

C N E N